This is a support bracket designed to strengthen, or repair the back on a Pelton and Crane Chairman and keep them from breaking at the base where they tend to break. Made from Plate Steel and bet to fit with predrilled holes, they attach in a relatively short time, and come with a complete set of instructions and hardware.
The Pelton and Crane Chairman Bellows Support Kit is used to support plastic bellows housings that have cracked, or holes no longer support the screws. This steel bracket allows you to attach it to broken bellows housings and then firmly attach it to the base of the existing chair. It includes 2 brackets, one for each side, and mounting hardware.
The Pelton & Crane headrest glide allows the headrest to slide up and down without turning sideways. It requires pulling off the 6 screws that hold the top upholstery on, and removing the old glide. Then installing the headrest glide, and reinstalling the upholstery. Total time should be less than one hour and experience level on a 1-10 scale with 10 being difficult is around a 3-4.
These parts are not commercially available, so I began making them off my CNC out of a solid piece of Delrin. They are much stronger than the original piece, and come with a one year warranty.
This part is no longer made by Kavo. We checked everywhere we could before we decided to begin making them. This is designed to fit the KCH 100 – The Environment dental chair. I am now making 2 differemt versions of this same part. One is 3d printed nylon (90 day warranty) and has had extremely good success with average sized patients. I also make a heavy duty version out of milled Delrin (5 year warranty). If this piece breaks, the back of the chair will not go up properly. It is an easy replacement that should take less than an hour.
Replacement for the Kavo Enviroment Chair (KCH-100) hanger that is no longer available. Direct replacement with a new DCI actuator installed. Made from 645 Nylon.
Are you tired of your steam sterilizer ruining your cabinetry. This has been a problem with Tuttnauers for ages. However, our custom made steam vent kit is made to direct steam out from under cabinets to help prevent damage to overhead cabinetry. (Please note, this will move the majority of steam forward by up to 9″.) It will fit the standard size Tuttnauer hole on 1730M, 1730MK, 2340M, 2340MK, 2340E, 2340EA, 2540M, 2540MK, 2540E, 2540EA, and EZ9, EZ10, and EZ11 series. Other models include the OCM and OCR by Pelton & Crane which we can easily custom make for you for the same price. Just include the unit type in the comments section and we will adjust accordingly.